Joined
·
1,813 Posts
What tube set is used?
Here's an explanation of seatpost/seat tube diameters from a practical POV. I don't know who the original author is and would certainly credit him/her if I knew.
"27.2mm became the standard seat-post size because most high-end road frames in the 1970s and 1980s were lugged and were almost universally made out of Columbus SL or SLX or Reynolds 531. These seat tubes were 1-1/8” in diameter, or 28.6mm. The single-butted seat tube was 0.9mm thick at the bottom and 0.6mm thick at the top. Well, 2x0.6mm = 1.2mm, which, when subtracted from 28.6mm, yields an I.D. of 27.4mm. However, the tolerance on the wall thickness and roundness of the seat tube made it so that you rarely could fit a 27.4mm post inside, even before brazing. And then, the seat tube always got distorted during brazing, making it even less possible to fit a 27.4mm in there, but a 27.2mm fit nicely. The same goes for why a 27.0mm seat-post was often used on the bigger sizes, which were made out of Columbus SP or SPX, whose seat tubes had 1.0 X 0.7mm wall thicknesses. Because of tolerances, the predicted 27.2mm post (28.6 – 2x0.7 = 27.2mm) never fit, but a 27.0mm fit nicely."
If yours is a large frame (say 60cm or bigger), the seat tube is likely Columbus SP or SPX, and the seatpost should be 27.0.
Here's an explanation of seatpost/seat tube diameters from a practical POV. I don't know who the original author is and would certainly credit him/her if I knew.
"27.2mm became the standard seat-post size because most high-end road frames in the 1970s and 1980s were lugged and were almost universally made out of Columbus SL or SLX or Reynolds 531. These seat tubes were 1-1/8” in diameter, or 28.6mm. The single-butted seat tube was 0.9mm thick at the bottom and 0.6mm thick at the top. Well, 2x0.6mm = 1.2mm, which, when subtracted from 28.6mm, yields an I.D. of 27.4mm. However, the tolerance on the wall thickness and roundness of the seat tube made it so that you rarely could fit a 27.4mm post inside, even before brazing. And then, the seat tube always got distorted during brazing, making it even less possible to fit a 27.4mm in there, but a 27.2mm fit nicely. The same goes for why a 27.0mm seat-post was often used on the bigger sizes, which were made out of Columbus SP or SPX, whose seat tubes had 1.0 X 0.7mm wall thicknesses. Because of tolerances, the predicted 27.2mm post (28.6 – 2x0.7 = 27.2mm) never fit, but a 27.0mm fit nicely."
If yours is a large frame (say 60cm or bigger), the seat tube is likely Columbus SP or SPX, and the seatpost should be 27.0.
