Road Bike, Cycling Forums banner
1 - 3 of 3 Posts

·
the other white meat
Joined
·
29 Posts
Discussion Starter · #1 ·
I'm having ongoing loose headset problems with the integrated headset on my Salsa Campeon frame. The Campeon fork has a carbon steerer which, of course, requires the use of a compression plug rather than a traditional star nut. I've been using a Cane Creek IS-6 headset since the bike was new last spring. Recently, I decided to change my stem and now am having serious issues getting the headset to tighten back down. It seems like regardless of how much I torque down the compression plug, I can't get rid of play in the headset. What am I missing here? I don't want to reef too hard on the compression plug nut, for fear of damaging the steerer, but I also don't want to ovalize the headtube because the headset is not tight enough. Any tips or tricks out there for this setup? FWIW, I'm using a Problem Solvers compression plug. Thanks.
 

·
the other white meat
Joined
·
29 Posts
Discussion Starter · #4 ·
already tried them all

merckx56 said:
The stem likely isn't as tall as our old stem, so the top cap isn't pulling down on the stem itself. Try one or all of these three fixes.

1)Put a spacer under the stem to make up the difference.
2)Put a spacer on top of the stem, under the top cap.
3)Tap the bottom/expander part of the compression device down a little inside of the steerer tube. Be very carfeul though, as it may drop all the way in the steerer.
It has a slightly shorter stack height than the old stem, which I accounted for using one additional 5mm spacer. All's good if I put the spacer under the stem, but that puts my handlebar too high. If I try to put the additional spacer between the cap and the top of the stem, the headset will not tighten down for sh*t. I've never had this problem with a normal headset/starnut combo.

Ah, frick. I guess another trip to the shop is in order...maybe I need the steerer tube cut down some more, because this stupid compression plug only seems to work if the top cap (which is an integrated piece of the Problem Solver compression plug - see photo) rests directly on the top of the stem itself - it doesn't seem to work if you put a spacer between the top cap and the stem. "Problem Solver" my hairy butt!
 

·
the other white meat
Joined
·
29 Posts
Discussion Starter · #5 ·
TurboTurtle said:
Sorry if this is aleady knowm, but I can't tell just reading your post. The stem is loose when you tighten the top cap screw, right?
Loosen the stem.
Tighten the cap screw to set the headset tension.
Tighten the stem to hold it in place.

TF
Thanks for the input; I guess my post wasn't clear that I'm kinda past those basics. I think that the combo of an integrated headset and a carbon steerer just doesn't work for diddly squat.
 
1 - 3 of 3 Posts
Top