Road Bike, Cycling Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all, just bought an FR-316 frame from Flyxxi (very impresed with service and communication) and in the frame are 2 holes for Di2, one is in the downtube & one in the chainstay in addition to the internal cable routing. As i am not going down the Di2 route what would be the best method to securely/aesthetically cover/fill these 2 holes

thanks in advance
 

·
Registered
Joined
·
2,507 Posts
I'd mold a silicon plug.
 

·
Registered
Joined
·
3,424 Posts
I'd just cover the holes with some tough tape. If that is too ugly, go to a sign shop (the kind that prints vinyl signs for sticking on commercial vehicles, does custom stripes for cars, etc.). They will have a million colors of very tough, but thin, vinyl, and I'd bet they'd give you a scrap. I've used this stuff for various purposes including covering stuff on bike frames, and it holds color and you will either be able to match the color OK or make something that looks like a factory decal/detail on your bike.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top