Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
I used Enduro bb86 bearings; they came in derlin cups. I applied a very, very thin layer of ptfe grease to the derlin cup area that makes contact with the bottom bracket of the frame. Nothing on the bearings that contact the cups. Lube on the bearing that contacts the spindle. Then I followed crankset install guide for lube points on crankset.
3500+ miles since install through rain, freezing temps, dust and races with no squeaks or problems. However, I did pull off the cranks around 2k to check and grease was everywhere it was suppose to be. I have loctite but I decided to see how a standard install would fair. Its not that difficult to pull the crankset off if I had problems.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top