Road Bike, Cycling Forums banner
1 - 3 of 3 Posts

· A wheelist
Joined
·
11,689 Posts
Discussion Starter · #3 ·
FTM said:
I have, although, I had my frame made for it. I just drilled a small hole in the Thomson post, that's about it.
Nice. I like the hole reinforcement on the back of the ST. My seat tube slot will be on the back side (my frame isn't here yet) and I was thinking of using the anti-crack hole at the bottom of the slot for the exit hole.

My rear brake will have full length outer casing so maybe I'll drill the seat post collar, counter-bore it to take the outer casing, drill the frame behind it and have the inner cable exit though the anti-crack hole.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top