Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
This is my first time to try to install tubulars. I put two coats of glue on tire and rim waiting 24 hours in-between for drying. Then I put a third layer on the rim and let dry for 15 minutes, than installed the tire. The problem was when I went to straighten the tire (which I tried immediately after installing) there was no moving it! I tried till I had blisters, but just wouldn't do. The glue worked too well!! Question: Was 15 minutes on the last coat too long before installing the tire?? Not long enough??? Any ideas where I went wrong? Thanks for your input.
 
1 - 1 of 1 Posts
Top