Road Bike, Cycling Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I was wondeing if anyone has any experience converting the HED Ardennes over to tubeless using the Stans tape. I wasn't sure if the wider 23mm rim would cause any issues. Does anyone have any experience with this setup?
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #5 ·
Sypher, did you ever run the Ardennes with tubes? If so how does it compare now that you are running tubeless? I noticed a pretty significant increase in ride quality when I switched to the Ardennes from my old rims, and I'm wondering if gets even better with tubeless.
 

·
sypher
Joined
·
8 Posts
This may be a repost...but in short if you ride on pavement (not dirt roads) you'll love road tubeless. I ride on a lot of dirt, and started getting a lot of bad/messy flats. I'd rather deal with tubes than sealant.
In two years of riding on pavement I never got a flat (at about 77psi). Good luck
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top