Road Bike, Cycling Forums banner
1 - 3 of 3 Posts

·
Parlee fan!
Joined
·
747 Posts
Discussion Starter · #1 ·
Hi Guys!

Just a question. Apart from using crazy glue to attach a computer magnet to a rear disk wheel, what's the best way to install it on the surface without damaging the wheel?

Thanks!


Joe
 

·
Registered
Joined
·
11,555 Posts
Rubber cement or anything similar. It allows you to peel the magnet back off and clean the wheel surface if you need to. I used to use tubular tire glue—held nicely, allowed me to slightly reposition the magnet while it was drying, and was easily removed with a mild solvent and a couple of minutes of work.

Crazy glue is forever, I wouldn't use it on a disc wheel.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top