Road Bike, Cycling Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter · #1 ·
Has anyone tried to fabricate a homemade carbon bottle cage? It seems to me if you can get your hands on some resin-impregnated sheets of carbon fiber, it shouldn't be too hard to make. Could you just wrap your cut-out design around a 'mold' that is the same diameter as a water bottle, then cure in the oven? I'd imagine you can drill the holes for the mounting bolts later on. Is it really tough to cut through the carbon sheets? I understand those aramid fibers are plenty tough, but couldn't you do it with a jigsaw?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top