Road Bike, Cycling Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
hi. i have sram red rear derailleur. i need to swap out the bottom pulley on the rear
derailleur. i see one hex bolt/screw that is holding the pulley in place. is there any
gotcha in swapping this out? should be very easy?
:confused:
 

· Registered
Joined
·
14,776 Posts
Very easy

hhssss said:
hi. i have sram red rear derailleur. i need to swap out the bottom pulley on the rear
derailleur. i see one hex bolt/screw that is holding the pulley in place. is there any
gotcha in swapping this out? should be very easy?
:confused:
Just like it looks. Just keep track of the little parts when it falls out, so you put them back in right. I don't know Sram specifically, but if it's like the traditional ones, theres the pulley, a bushing, 2 end covers for the bushing, and the screw.

Obviously, remove the chain first, or at least slip it off the chainring to slacken it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top