Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
84 Posts
they're fine...

The notches are big enuf to hold the cog perfectly.

Do tighten down your lockring to feel secure though, as it does look a little scary, at first.

I found w/a Phil lockring, I had to reverse it because the shoulder hit just below the notches. Not a problem, but it means that the lockring notches are then flush to the cog, which, in turn means, that you'll not be able to use a Var plier type tool to remove the lockring. Old Park SPA-3 works fine...

Also, after each of the first couple of rides, tighten down the lockring, again, as the cog and carrier have tightened themselves down on the hub.

PH
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top