Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
336 Posts
If I'm not mistaken, there are two different exit routes you can use for the shift cable coming out of the shifter. I would remove the tape and pull back the hood and check to see if maybe you should use the other exit experimenting with the routing on the bar you wanted to try. I think also you can remove 3 screws on the little access plate and watch what is happening when you shift it up/down. Also check for crap in there.

Something else to consider is there are two different diameter shift cables, and SRAM specs the thinner (1.1 mm ) cable. If you used thicker (I think it is 1.2) that might make a difference (I currently run Yokozuna cable which I think is 1.2 and it works, but I think it might drag more than 1.1 would).

scott s.
.
 
1 - 1 of 1 Posts
Top