Road Bike, Cycling Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
152 Posts
Discussion Starter · #1 ·
Maybe it is just me but I just purchased a set of Purley Custom bar ends for my road bike and, well I just don't seem to know how to make them fit. They have a plug with a rubber stopper and a nut but no way to adjust the tension once the plug is in place. I have used Hope bar ends in the past and they have a screw that is turned once the bar end is in place to expand the rubber stopper. Hopefully I am just making this more complicated then it is.
 

·
Militant commuter
Joined
·
943 Posts
You're quite welcome...I stumbled upon the installation instructions when I was responding to another recent Purely Custom thread, so your question had good timing!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top