Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Help!!!! I am replacing my old bearings in my Velomax Orion Rear Hub. I reasearched and purchased the right size bearings; however, removing the drive side bearing is a beast. :mad2: :mad2: The archived material on the Easton website says to "use a rubber mallet, hit the non-drive side of the Axle and drive the fixed Bearings out of the other end". For the life of me, I cannot get this out. Is there something I'm missing. I dont want to continue banging with this mallet as I fear damaging the axle or rim. Anyone know any tricks or have any experience similar and could offer advice?
Thanks
 
1 - 1 of 1 Posts
Top