I'm trying to replace the bearings in a Ritchey WCS Zero rear hub. A 5 mm allen fits in both sides of the axle and I can get the freehub off by unscrewing the end cap. Not sure how to get the non-drive cap off unless I hold the drive side somehow.
Can I tap on the drive side of the axel and push the bearing on the non-drive side out? If so, I then have to figure out how to get the drive side bearing out.
Any advice you have will be helpful. I can't find what I need on the Ritchey website.
Can I tap on the drive side of the axel and push the bearing on the non-drive side out? If so, I then have to figure out how to get the drive side bearing out.
Any advice you have will be helpful. I can't find what I need on the Ritchey website.
