Road Bike, Cycling Forums banner
1 - 2 of 2 Posts

· Formosan Cyclocross
Joined
·
3,380 Posts
Discussion Starter · #1 · (Edited)
My wheel that is.

The story is... I just completed a build with my LBS a couple weeks ago and very quickly... with the help from some sharp eyes from RBR found the wheel builder had improperly laced my rims radially rather than 3 cross, against the instructions of the hub manufacturer. Luckily, I hadn't had a chance to ride beyond a tester or two and promptly had the wheels rebuilt 3 cross.

A week later, after about 50 miles of riding... the front wheel started to "creak". I immediately checked the spoke tension and found several of the spokes were really loose and all were somewhat loose . One spoke I could tighten by hand. The wheel was visually not true (drifting laterally).

The rear wheel was fine...

I have discs on front and rear and do most of my braking on the front. My concern is that the tension from the disc is causing the front spokes to come loose. Or... the mistake before has caused some kind of damage to the rim...gulp..or hubs. Is this just a case of new wheels "settling"? Poor workmanship? Poor combination of components? Damage? My builder sent them back to the wheel builder AGAIN...but maybe you all could lend a hand.

I'm running (new style) DT RR1.1 rims
Chris King ISO Disc Hubs
DT Spokes with Brass Nipples (x32)
Continental GP 4000 Tires
Shimano BR 505-R Disc Brakes w/ 160mm Rotors.


Thanks in advance!
 

· Formosan Cyclocross
Joined
·
3,380 Posts
Discussion Starter · #3 ·
Actually.. I come to find... it's a wheel factory...and I'm gonna find out where it is and see who these guys are. I'm picking up my wheels tomorrow to do it myself. I was able to do enough with a spoke tool to get home safely. I needs to tear everything out of my spare bedroom and make a work space for more DIY repairs.

Thanks Mike T
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top