Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
167 Posts
Discussion Starter · #1 ·
All,
I ordered up some Sun TA1's and a set of Formula High Flange Track Hubs for my fixie. Using a spoke calculator, I came up with 285.5 in the front, and 285.1 in the back, using a 3x pattern (32 hole). DT offers either 284 or 286 precut lengths. Would it be better to be abit short, or abit long ? If anyone cares to double check, here's the specs I have

ERD - 590mm

Front
Width from center to flange 34.5 mm
Flange diameter 62.0 mm
Rear
Width from center to flange 31.0 mm
Flange diameter 62.0 mm

Thanks !
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top