Road Bike, Cycling Forums banner
1 - 1 of 1 Posts

117 Posts
A piece of plastic pipe

It work like a charm. Support the fork with a 2X4 at the crown, NOT on the dropouts and just hammer it down until it seats firmly.

If you need a press for the cups, use a big long threaded bolt, some fender washers, nuts, and 2 samll blocks of wood with a hole drilled thru them. This crude press has installed over 20 headsets for me flawlessly, including several Chris Kings.

Look at all the headset tools you can and you will find they are all glorified versions of what I described above. Good luck ...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.