[dcgriz]

One more vote on two layers of Stan's 21mm tape for 17mm internal width rims for either tubed or tubeless tires. As said earlier, run it as far out on the bead shelf and under the bead hook as you can.

 

[dcgriz]

I prepped the internals of the spoke holes with a countersink and blew lots of compressed air into the rims when done. No problems with shavings in my set.

Good thing you did but this is ridiculous! I cant see why this is left to the customer to do and in the process also exposing them to taking the chance of over-countersinking the spoke hole.

 

[dcgriz]

Ron has posted here his deburring process for these rims but still I believe this should be done at the factory before the rims are released for sale.